maser

A maser is a device that produces coherent electromagnetic waves through amplification due to stimulated emission. Historically the term came from the acronym "Microwave Amplification by Stimulated Emission of Radiation", although modern masers emit over a broad portion of the electromagnetic spectrum. This has led some to replace "microwave" with "molecular" in the acronym, as suggested by Charles H. Townes.[1] When optical coherent oscillators were first developed, they were called optical masers, but it has become more common to refer to these as lasers. See the section on terminology below for more on this.Theoretically, reflecting principles previously discussed by Joseph Weber at the June 1952 conference of the Institute of Radio Engineers,[2] the principle of the maser was described by Nikolay Basov and Alexander Prokhorov from Lebedev Institute of Physics at an All-Union Conference on Radio-Spectroscopy held by USSR Academy of Sciences in May 1952. They subsequently published their results in October 1954. Independently, Charles H. Townes, J. P. Gordon, and H. J. Zeiger built the first maser at Columbia University in 1953. The device used stimulated emission in a stream of energized ammonia molecules to produce amplification of microwaves at a frequency of 24 gigahertz. Townes later worked with Arthur L. Schawlow to describe the principle of the optical maser, or laser, which Theodore H. Maiman first demonstrated in 1960. For their research in this field Townes, Basov, and Prokhorov were awarded the Nobel Prize in Physics in 1964.Today, the most important type of maser is the hydrogen maser which is currently used as an atomic frequency standard. Together with other types of atomic clocks, they constitute the "Temps Atomique International" or TAI. This is the international time scale, which is coordinated by the Bureau International des Poids et Mesures, or BIPM.

It was Norman Ramsey and his colleagues who first realized this device. Today's masers are identical to the original design. The maser oscillation relies on stimulated emission between two hyperfine levels of atomic hydrogen. Here is a brief description of how it works:

* First, a beam of atomic hydrogen is produced. This is done by submitting the gas at low pressure to an RF discharge (see the picture on this page).

* The next step is "state selection"—in order to get some stimulated emission, it is necessary to create a population inversion of the atoms. This is done in a way that is very similar to the famous Stern-Gerlach experiment. After passing through an aperture and a magnetic field, many of the atoms in the beam are left in the upper energy level of the lasing transition. From this state, the atoms can decay to the lower state and emit some microwave radiation.

* A high quality factor microwave cavity confines the microwaves and reinjects them repeatedly into the atom beam. The stimulated emission amplifies the microwaves on each pass through the beam. This combination of amplification and feedback is what defines all oscillators. The resonant frequency of the microwave cavity is exactly tuned to the hyperfine structure of hydrogen: 1420 405 751.768 Hz.

* A small fraction of the signal in the microwave cavity is coupled into a coaxial cable and then sent to a coherent receiver.

* The microwave signal coming out of the maser is very weak (a few pW). The frequency of the signal is fixed but extremely stable. The coherent receiver is used to amplify the signal and change the frequency. This is done using a series of phase-locked loops and a high performance quartz oscillator.